Hi,
We have billed an installation.
Previously the QUANTI04 step in our rate used to make an entry in DBERCHZ2.
But now, the same step is not updating the table anymore.
(Between now and then, other parts of the system has been touched/altered, the condition for step execution has been changed. But the ratestep, variant control and variant/operands remain untouched)
Is there any configuration that could have been messed up, which is stopping the table from being updated?
What could be causing this problem?
[
Please do note that, I have already looked around and found this could be a input issue linked to time fields on SE16 selection screen.
I have tried the suggested solutions to change the upper limits on those fields.
I could not find any entries through SE16, SE16N, Select statement-using just BELNR.
]
Regards,
Joshua.