Hi all,
I am doing rate category comparison using EASIM (Simulation scenario) functionality and maintained required configuration for alternative rate category.
If I maintained the meter reading (using El28) for next billing period and trying to run simulation for same period (start bill period and end bill period on EASIM screen)system is giving information message “Enter valid meter reading” and not allowing to simulate.
But whereas if there is no meter reading entered for next bill period, system is simulating bill correctly
Also If I change MR in meter reading tab page , it is also not working.
Am I missing something?
Using below Config:
Simulation Scen. Category: Simulation Period with Rate Category Comparison and alternative rate categories are maintained.
Thanks in advance,
Chetan