Hi,
Our requirement is the following:
We want to apply a synthetic profile to an installation that carries a dual rate register (high-peak/low-peak).
As far as we understand, the standard only allow to determine A SINGLE Usage factor for the total consumption of the installation (provided throught QUANTI24): Usage factor = TOTAL consumption (billed) / TOTAL consumption (synthetic profile)
From our point of view, we would need one usage factor per register, in order to allocate the high-peak/low-peak consumption to the corresponding periods.
The synthetic profile would therefore be applied to the consumptions provided by the two registers according to high/low periods defined by the "Day profiles" defined on the "Sythetic profile".
Thanks a lot for your help.
Sebastien